Kentrox RMX-3200 - Page 217

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Relay Outputs: Configuring SNMP to Operate a Relay Output
20-7
7. (optional) Verify that action snmpOutputClose has been configured properly:
show actions snmpOutputClose
The command response similar to the following displays:
8. (optional) Verify that action
snmpOutputOpen has been configured properly:
show actions snmpOutputOpen
The command response similar to the following displays:
9. Save the configuration.
10. To cause the events to occur, issue an SNMP set on the aiMediation event object,
which is in the aiMediationV2 MIB. Use the same names that were used for the
manager sets in the SNMP events (
output4_close and output4_open).
(Dub)>show actions snmpOutputClose
Action Name : snmpOutputClose
Action Description :
Event Name : snmpClose
Event Description :
Event Originator : snmp
Event Type : manager-set output4_close
Response Name : switchClose
Response Description :
Response Responder : output 0/4
Response Type : close
Response Parameters :
No parameters configured for this response.
(Dub)>
(Dub)>show actions snmpOutputOpen
Action Name : snmpOutputOpen
Action Description :
Event Name : snmpOpen
Event Description :
Event Originator : snmp
Event Type : manager-set output4_open
Response Name : switchOpen
Response Description :
Response Responder : output 0/4
Response Type : open
Response Parameters :
No parameters configured for this response.
(Dub)>