Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Controllers and Interfaces: Configuring T1/E1 Line Encapsulation Settings
7-8
6. Configure maximum number of data bytes that can be transmitted (mtu) in a
single PPP frame as
5400 on controller serial wan/1:
config controller serial wan/1 channel-group group encapsulation
ppp mtu 5400
7. Configure the inactivity-timeout on controller serial wan/1 for 20 minutes:
config controller serial wan/1 channel-group group encapsulation
ppp inactivity-timeout 20
8. Configure the remote authentication method as pap on controller serial wan/1:
config controller serial wan/1 channel-group group encapsulation
ppp remote method pap
9. Configure remote username usera and remote password password for
authentication on controller
serial wan/1:
config controller serial wan/1 channel-group group encapsulation
ppp remote identity usera password
10. Configure controller serial wan/1 to be part of bridge switch (this is BCP
configuration):
config controller serial wan/1 channel-group group bridge switch
To Next Page
Loading...
