Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Controllers and Interfaces: Configuring T1/E1 Line Encapsulation Settings
7-9
11. (optional) Verify that the encapsulation settings on controller serial wan/1 have
been configured properly:
show controllers serial wan/1
The command response similar to the following displays (for a T1 controller):
12. (optional) Configure HDLC encapsulation for controller
serial wan/2:
config controller serial wan/2 channel-group group encapsulation
hdlc
Note: Remote RMX-3200 does not support HDLC bridging.
(Dub)>show controllers serial wan/1
serial wan/1 status=enabled
resource-state=unassigned
rx-link-state=LOF
tx-link-state=up
local-loop=norm
remote-loop=norm
buildout=-7.5dB
clock=loop
framing=d4
linecode=b8zs
framer-crc-errors=0
framing-errors=403315940
line-coding-violations=0
severely-errored-framing-events=0
desc=T1 port
channel-group=group status=enabled
system-name=hdlc0
speed=64
encap=ppp
timeslot=1-5,7-16
ppp defaultroute=true
local-method=chap local-identity=userb
remote-method=pap remote-identity=usera
mru=5200 mtu=5400
lcp-requests=enabled
inactivity-timeout=20
(Dub)>
To Next Page
Loading...
