Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Measurements and the Measurement Table: Configuring a Measurement Table Entry for
State Transitions and Durations
16-11
The command response similar to the following displays:
(Dub)>show meas-table entries ExtTemp1_Transitions
Name – ExtTemp1_Transitions (static)
State – in-band
Originator - @state-transitions ( alarm-entry ExtTemp1 , major )
Description – Number of External temperature high alarms
NE Name -
Category -
Report Interval - 0
Low-Band - 0
High-Band - 0
Hysteresis - 0
Max-Limit - 0
Min-Limit - 0
Units -
Current Value - 3
Interval Value - 0
Interval Minimum - 0
Interval Maximum - 0
Interval Average - 0
(Dub)>
To Next Page
Loading...
