Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Mediation Connections: Configuring a SSH to Asynchronous Serial Connection
17-10
5. Configure controller serial 6 to connect and disconnect as DCD goes active and
inactive:
config controller serial 6 connect mode dcd
config controller serial 6 disconnect mode dcd
6. Configure the application mode as destination:
config controller serial 6 application destination
7. (optional) Verify that a connection is established:
show connections
The command response similar to the following displays:
Note: The 4 that comes after the TCP port number is an internal reference
number generated by Remote RMX-3200.
8. (Optional) Create a new user named
ebh, password jimbo, with the
restricted profile, authorizing this user for terminal server access:
config users add ebh restricted jimbo jimbo
9. (Optional) Configure the aimediation service (the default) on the TACACS+
server, which will be used when authenticating users for mediation:
config mediation default tacacs-service
Note: You will need to add priv_lvl=0 to the aimediation service on the
TACACS+ server.
10. Save the configuration.
(Dub)>show connections
ssh 10.40.57.5:20001:4 -> serial 6
(Dub)>
To Next Page
Loading...
