Kentrox RMX-3200 - Page 204

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring DHCP: Configuring a DHCP Server
19-4
5. (optional) Verify that the DHCP server has been configured properly:
show dhcp-server
The command response similar to the following displays:
6. Save the configuration.
Tip: Remote RMX-3200 lets you specify a DHCP server configuration file. This file
overrides any DHCP server settings configured in the Remote RMX-3200 CLI. If
you do not specify the correct DHCP server configuration file, Remote RMX-
3200 generates an error. The following command specifies file
dhcpconfig1.txt as the DHCP configuration file:
config dhcp-server config-file dhcpconfig1.txt
The DHCP server configuration file must exist in Remote RMX-3200 directory
/config/dhcp before you can specify it as the configuration file in the Remote
RMX-3200 CLI. For information about creating a DHCP server configuration file,
refer to the dhcpd.conf man page.
(Dub)>show dhcp-server
Admin State: disabled
Broadcast: enabled
Authority: enabled
Config file:
Note: User specified configuration files will override configured
DHCP server settings.
Interfaces:
bridge switch
Subnets:
234.55.0.0/16 range=0.0.0.0/0.0.0.0 router=0.0.0.0
default-lease=3600 max-lease=28800
DNS:
Hosts:
(Dub)>