Kentrox RMX-3200 - Page 252

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring the SNMP Proxy: Configuration Results
22-18

Note: Alarms, events, actions and responses for SNMP proxy will not display in
running-config as they are implicitly added to the configuration. Only if the
user makes a change to one of the entities will these four items display in
running-config. This applies only to new SNMP proxy configurations, not
those loaded from saved configurations.
The configuration will add the following alarm entries and actions automatically.
config alarm-entry ProxyNE_ethernet1_snmpne
event snmpne ProxyNE point ethernet1 trap up event $(message)
event snmpne ProxyNE point ethernet1 trap down event $(message)
ne-name MyNE
category some-category
config alarm-entry ProxyNE_ethernet2_snmpne
event snmpne ProxyNE point ethernet2 trap up event $(message)
event snmpne ProxyNE point ethernet2 trap down event $(message)
ne-name ProxyNE
category some-category
config event ProxyNE_reboot_snmpne content snmpne ProxyNE trap reboot
config response ProxyNE_trap_snmpne content snmp trap
message $(message)
ne-name ProxyNE
category some-category
config action ProxyNE_reboot_snmpne
event ProxyNE_reboot_snmpne
response ProxyNE_trap_snmpne