Remote RMX-3200 Version 5.2x Configuration Guide
Configuring the Peripheral Management Subsystem: Expansion Peripheral States
25-12
Initializing
Specifies that Remote RMX-3200 has established a
management connection to the peripheral and is
exchanging initial setup messages with it.
IncompatibleManaged
Specifies that the following conditions exist:
Remote RMX-3200 has successfully set up and
initialized a management connection to the
peripheral.
The peripheral’s firmware is incompatible with
Remote RMX-3200’s firmware.
Remote RMX-3200 is not currently downloading
compatible firmware to the peripheral (and perhaps
cannot, for some reason).
When a peripheral is in this state, only basic peripheral
management functions are available, such as updating
the image and reloading.
Downloading
Specifies that Remote RMX-3200 is downloading a new
firmware image to the peripheral.
Managed
Specifies that Remote RMX-3200 has successfully set
up and initialized a management connection to the
peripheral.
Online
Specifies that the peripheral is fully operational. Remote
RMX-3200 has established a management connection to
it and it is fully functioning as part of Remote RMX-3200.
Table 25-2 Potential Expansion Peripheral Operation States (Continued)
Operation State Description
To Next Page
Loading...
