Remote RMX-3200 Version 5.2x Configuration Guide
:
Glossary-5
channel group
A channel group consists of one or more channels in a T1/E1 link grouped together as
a high-speed virtual path. A channel group treats all 24 channels of the T1 and all 32
channels of an E1 as a single data stream. A user can create one channel group for
each serial controller.
chat file
A chat file contains the connection initialization string for ports that are configured for
PPP encapsulation. It is stored in the /config/chat directory on Remote RMX-3200.
The user must FTP the chat file to the /config/chat directory on Remote RMX-3200
prior to configuring the file as the connection initialization string.
CLI
Command line interface. A user interface whereby the user types one line of
instructions at a time at a command prompt.
CLI session timeout
The command line interface (CLI) session timeout is the amount of time (in minutes)
that can elapse before an Remote RMX-3200 session expires due to inactivity.
clock source
The clock source determines how a serial controller’s clock is set. The two options are
loop and internal. The loop option frames Remote RMX-3200 controller packets
based on the line timing from the incoming T1 link. The internal option frames Remote
RMX-3200 controller packets based on the Remote RMX-3200 generated clock.
community string
A community string is a password used with the SNMP protocol that is used for both
read-only and read-write privileges.
condition type
A condition type refers to a TL1 alarm type that is based on standards listed in the
Bellcore GR-833-CORE documentation.
To Next Page
Loading...
