Remote RMX-3200 Version 5.2x Configuration Guide
:
Glossary-23
RAS authorization
RAS authorization is the method by which Remote RMX-3200 grants command
access when TACACS+ remote authentication is configured. Access can be granted
based on command level or privilege level. Command level authorization requires
Remote RMX-3200 to contact the TACACS+ server for each command the user runs.
Individual commands are then allowed or denied. Privilege level authorization
configures the TACACS+ authorization method based on the privilege returned from
the TACACS+ server.
RAS server
A RAS server is a device that provides user authentication and provisioning for
access into the network using RADIUS software or the TACACS+ protocol.
RAS timeout
The RAS timeout is the amount of time that the device waits for a response from the
RAS servers before falling back on local authentication.
raw alarm output
Raw alarm output is an Remote RMX-3200 alarm format that contains all information
about the alarm and the event that caused it. It can be used for alarm formats that are
not directly supported by Remote RMX-3200. A script or application can take the
alarm information from the raw output and translate it into any type of alarm message.
relay output
Relay outputs can close or open an external circuit to cause connected devices to
respond.
remote access protocol
The remote access protocol defines the methods for establishing a CLI session and
transferring files.
To Next Page
Loading...
