Remote RMX-3200 Version 5.2x Configuration Guide
:
Glossary-28
T
TACACS+
TACACS+ is a protocol that provides remote user authentication.
task position
A task position is the order in which a task will be executed within Remote RMX-3200.
The position indicates where in the list a task should appear. Unless a user specifies a
new position for a task, Remote RMX-3200 adds new tasks to the end of the list.
task property
A task property is a required or optional parameter for a task. These parameters differ
depending on the task type (ifconfig or serversocket) configured for a task.
task type
There are two types that can be assigned to a task. The task type ifconfig creates a
subinterface for the job, which lasts for the lifetime of the job. The task type
serversocket binds a socket for the lifetime of the job.
TBOS alarm/status points
TBOS alarm/status points represent individual alarm points on an attached TBOS
display.
TBOS control points
TBOS control points control relay outputs on attached TBOS devices.
TBOS definition file
A TBOS definition file is a tab-delimited or comma-separated file that contains
equipment type definitions (TBOS NE display templates).
To Next Page
Loading...
