Konica Minolta Image Controller IC-402 - Page 186

Copier Network Functions
6
IC-402 6-15
13 Specify the desired setting.
14 Touch [Fwd.→].
Setting Up LDAP screen 6/6 appears.
15 Specify the desired settings.
16 Touch [OK].
The LDAP server registration and authentication are set.
2
Note
To cancel changes to the setting, touch [Cancel].
To quit specifying the Utility mode setting, touch [Exit] in the sub display
area or press the [Utility/Counter] key. Otherwise, cancel the Utility mode
by touching [Close] in each screen until the screen for the Copy, Fax,
Scan or Box mode appears.
2
Reminder
If the LDAP server settings are not specified correctly, network failure
may occur. The server administrator should specify LDAP settings.