Issue 2.2
Feature Description and Operation Manual
178
12.4 Traffic Analysis
Description
The ipLDK can monitor, store and, periodically or upon request, output various traffic statistics
covering system resources. The output from the system can be used to:
Monitor and evaluate system performance
Observe usage trends and recommend possible corrective actions,
Determine possible trunk problems, i.e. blocking level too high, and/or
Recommend system upgrades.
Attendants enable Periodic Reporting. Once enabled, the system continues to monitor and
output the requested report until Periodic Reporting is disabled. On-demand reports selected
by the System Attendant are output only upon request. The Traffic Report is sent to the
defined system RS-232 port or Modem port.
System resources covered by Traffic Reports are:
Attendant Traffic Report
Call Summary Report
Hourly Call Report
H/W Unit Usage Summary Report
CO Summary Report
Hourly CO Report
Reports for each report can be printed or the All Summary Traffic Reports can be selected to
print the Call, H/W and CO Summary reports. Summary Traffic Reports cover one of five
Analysis periods selected at time of print:
1. Today’s peak activity hour (within 24 hours)
2. Yesterday’s peak activity hour (24 hours prior to Today’s activity)
3. Last hour activity
4. Today’s total activity
5. Yesterday’s total activity
Operation
To print the All Summary Traffic Report from the System or a Main Attendant,
1. Press the [TRANS/PGM] button.
2. Dial ‘0 1 2 2’, the All Summary report code.
3. Dial the hour and minute for the print
4. Using the Volume Up/Down button select the Analysis Period
5. Select Analysis Period (‘1’-‘5’).
6. When the Analysis period displays, press the [HOLD/SAVE] button.
To cancel the periodic All Summary Report from the System or a Main Attendant,
1. Press the [TRANS/PGM] button.
2. Dial ‘0 1 2 3’, the cancel All Summary report code.
To Next Page
Loading...
