LG-Ericsson ipldk-60 - System Timers III (PGM 182)

ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
122
3.5.21.3 System Timers III (PGM 182)
PGM 182 is one of three PGMs used to define timers that affect system wide operations. See also PGM 180 and 181.
Procedure:
1. Press the [TRANS PGM] button.
2. Dial 182.
3. Select the desired Flexible button.
4. Enter the appropriate value.
5. Press the [Hold/Save] button.
PGM
182
Flex
Btn
Description Default Values
SLT Hook Switch
Bounce Timer
1 This parameter defines the duration of a hook-switch transition considered a
spurious signal and ignored. If the signal is stable for a period longer than the
bounce time, it is considered a valid hook switch transition.
01 (100 milli-
seconds)
01 ~ 25 in 100 milli-
second increments
SLT Maximum
Hook Flash Timer
2 This parameter sets the maximum duration of a Flash (new dial tone request) from
an SLT. An open hook switch signal longer than the maximum is considered a
disconnect signal from the SLT.
075 (750 milli-
seconds)
001 ~ 250 in 10 milli-
second increments
SLT Minimum
Hook Flash Timer
3 This parameter defines the minimum duration of a Flash (new dial tone request) for
the ipLDK to register the Flash signal otherwise the signal is consider a spurious
signal.
020 (200 milli-
seconds)
000 ~ 250 in 10 milli-
second increments
SLT Ring Phase
Timer
4 This parameter defines the overall duration of ring signal sent to an SLT port. The
Ring-on period is fixed at 1 second. The remaining time is the Ring-off period. The
default is 1 second Ring-on and 4 seconds Ring-off for a total duration of 5 seconds.
5 seconds 2 ~ 5 in 1 second
increments
Station Auto
Release Timer
5 This parameter sets the length of time a station receives intercom Ring Back tone
before the call attempt is abandoned and error tone provided to the station. Also, the
060 seconds 020 ~ 300 in 1
second increments