ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
123
PGM
182
Flex
Btn
Description Default Values
station will receive Park recall for the Auto Release Timer.
Unsupervised
Conference Timer
6 This parameter sets the timer that controls the duration of an Unsupervised
Conference or other CO line to CO line connections.
10 minutes 0 ~ 99 in 1 second
increments
Wake-up Fail Ring
Timer
7 This parameter defines the duration of ring the System Attendant receives when a
user fails to respond to a Wake-up ring. A setting of ‘00’ disables the Wake-up Fail
Attendant alert.
20 seconds 00 to 99 in 1 seconds
increments
Warm Line Timer 8 This parameter sets the length of time the user may activate a feature or access a
CO line before the system activates the Warm line assignment. Also, see PGM 113,
Flexible button 7 and PGM 122
05 seconds 01 ~ 20 in 1 second
increments
Wink Timer 9 This parameter defines the duration of the Wink acknowledgement signal returned
by the system to a DID CO line.
010 (100 milli-
seconds)
010 ~ 200 in 10 milli-
second increments
Enblock Digit
Timer
10 This parameter determines the inter-digit time when Enblock dialing (PGM 143,
Flexible button 6) is enabled. When the timer expires, the system sends all digits
dialed in the call set-up message.
05 seconds 01 ~ 20 in 1 second
increments
CCR Time Out
Timer
11 This parameter defines the first and inter-digit time for a caller after receiving a CCR
Greeting. When the timer expires and the user dials no additional digit, the call is
routed using the digits dialed and the CCR table (PGM 228) routing.
015 seconds 000 ~ 300 in 1
second increments
DID Inter Digit
Timer
12 This parameter defines the length of time the system waits for each digit from a DID
CO line. When the timer expires, the system routes the call based on the DID
process defined.
05 seconds 01 ~ 20 in 1 second
increments
FAX Tone Detect
Timer
13 This parameter sets the time interval allowed for the system to detect FAX tone on a
CO line assigned for FAX mode, refer to PGM 161, Flexible button 17. After the
timer expires, the call is routed with ring to assigned stations.
05 seconds 01 ~ 10 in 1 second
increments
FAX CO Call
Timer
14 This parameter sets the time interval allowed for the FAX station port (8
th
station
port) to answer a FAX call. After expiration of the timer, the call is disconnected.
1 minute 1 ~ 5 in 1 minute
increments
To Next Page
Loading...
