ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
4
When a reset is required, PGM 450 Flexible button 15 may be used to
reset the system without the need to turn power ‘Off’ and ‘On’ or
opening the KSU to access the reset button.
To reset the system while in the Program mode,
1. Press the [TRANS/PGM] button.
2. Dial 450.
3. Press Flexible button 15.
4. Press the SAVE softkey, the system will reset.
2.2.5 Initial Set-up
The initial set-up of the ipLDK, as discussed in the Hardware
Description and Installation Manual, requires proper configuration of
the Basic Set-up Programs. This group of programs includes PGM
100 to PGM 109. PGM 100 defines the Nation Code, which is the
Country Code used for international dialing, to adjust various gain and
other characteristics to match the regulatory requirements of the
country or region as well as establish a default database. If the Nation
Code must be changed, the system database must be set to default to
assure all parameters are changed to match the new Nation Code. As
this will return all parameters to default values, the Nation code should
be changed as discussed in section 3.1.1 prior to any other
programming. During the system default routine, the system
automatically detects any installed expansion and option boards. If an
expansion or option board is installed after database initialization, the
board must be assigned in the system database and logically assigned
to a ‘slot order’.
To Next Page
Loading...
