LG-Ericsson ipldk-60 - SIP Attributes II (PGM 501, PC Admin Only)

ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
196
3.12.4 SIP Attributes II (PGM 501, PC Admin only)
PGM 501 is one of two PGMs used to configure SIP operation, see also PGM 500.
Procedure:
1. PC Admin only.
PGM
501
Flex
Btn
Description Default Values
User ID This parameter defines the SIP User Id that is used in the SIP ‘From’ header (ex:
caller@call.domain
). The Id is also used by the SIP Call server in the ‘To’ header to
route calls to the user.
Not assigned Max 64 characters,
see Dial Pad
Character Chart
Authentication
User Name
This parameter defines the User Name employed during the registration with the SIP
Call server to authenticate the user.
Not assigned Max 64 characters,
see Dial Pad
Character Chart
Authentication
User Password
This parameter defines the Password associated with the User Name and is
employed during registration with the SIP Call server to authenticate the user.
Not assigned Max 64 characters,
see Dial Pad
Character Chart
Contact Number This parameter defines the contact number used in the SIP ‘Contact’ header.
Typically the contact number is the station or DID number associated with the
contact.
Not assigned Max 12 characters,
see Dial Pad
Character Chart
User ID
Registration
This parameter determines if the SIP User Id will register with the SIP Call server as
defined n RFC3261. When the parameter is set to provision, the User Id is not
registered with the SIP Call server and a non-RFC method must be used to route
SIP calls to the system.
Provision Provision
Register
User ID Usage When enabled (On), the system will employ the User Id for CLI on SIP calls. In
addition, if User ID Registration is set to register, the User ID will also be employed
to register the user with the Call Server host.
Off Off
On