LG-Ericsson ipldk-60 - CO Line Attributes I (PGM 141)

ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
61
3.3.2 CO Line Attributes I (PGM 141)
PGM 141 is one of three PGMs that assign general attributes to the CO line range. Also, see PGMs 142 and 146.
Procedure:
1. Press the [TRANS/PGM] button.
2. Dial 141.
3. Enter the appropriate CO line Range.
4. Select the desired Flexible button.
5. Enter the appropriate value.
6. Press the [Hold/Save] button.
PGM
141
Flex
Btn
Description Default Values
CO line Group 1 This parameter defines the CO Group for the CO lines. Each CO line is assigned to
a CO Group with other CO lines having similar characteristics. Group 00 is for
Private lines and Group 25 is for unused lines.
01 00 ~ 25
CO COS 2 This parameter defines the Class Of Service (COS) for CO lines. The CO COS is
combined with Station COS (PGM 116) to determine dialing restrictions for a call.
CO COS 1: Station COS applies
CO COS 2: Exception Table A governs
CO COS 3: Exception Table B governs
CO COS 4: Restricts LD calls and Exception Table C
CO COS 5: Overrides Station COS 2~6 with no restrictions.
1 1 ~ 5
DISA Account
Code
3 When enabled (On), DISA callers attempting to place a CO line call must enter a
Station or System Authorization Code (PGM 227).
1 (On) 0 = Off
1 = On
CO Line Assign 4 This parameter determines the ‘Start’ and ‘Disconnect’ signal for the CO line, Loop 0 (Loop) 0 = Loop