ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
200
3.13.3 RSG/IP Phone Attributes I (PGM 382)
PGM 382 configures attributes of RSGs and IP Phones registered with the system.
Procedure:
1. Press the [TRANS PGM] button.
2. Dial 382.
3. Select the desired Flexible button.
4. Enter the appropriate value.
5. Press the [Hold/Save] button.
PGM
382
Flex
Btn
Description Default Values
Transfer Mode 1 This parameter defines the protocol layer used for communication between the IP
phone and the system. ipLDK-60 only supports IP.
0 (IP) 0 = IP
1 = MAC
Casting Mode 2 This parameter determines if the IP Phone will employ uni-cast or multi-cast signals
when attempting to register with the ipLDK.
0 (Uni-cast) 0 = Uni-cast
1 = Multi-cast
Tone Source 3 This parameter defines the tone source when connected to an RSGM. In the remote
mode, the RSGM provides tones, which reduces rtp traffic.
0 (Remote) 0 = Remote
1 = LDK
Peer to Peer 4 When enabled (On), a peer-to-peer connection is established between two IP
Phones in the same subnet and the call does not use a VOIB channel for RTP
packets.
1 (On) 0 = Off
1 = On
Codec Type 5 This parameter defines the default codec used by the system for a VoIP connection.
A different codec may be selected during the call set-up negotiation.
1 (G.711 u-Law) 0 = G.711_ALAW
1 = G.711_ULAW
2 = G.723.1
3 = G.729
4 = G.729A
To Next Page
Loading...
