ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
146
3.9.2 Enblock Prefix Table (PGM 205)
PGM 205 configures characteristics for Prefix code dialing.
Procedure:
1. Press the [TRANS PGM] button.
2. Dial 205.
3. Select the desired Flexible button.
4. Enter the table index (01 ~ 50).
5. Enter the appropriate value.
6. Press the [Hold/Save] button.
PGM
205
Flex
Btn
Description Default Values
Prefix code 1 This parameter defines the Prefix code number to match to the user-dialed digits. If
the dialed number matches an assigned Prefix code, the number is dialed.
Not assigned 8 digits, 0 ~ 9 and
[DND] for any digit
Min Digits 2 This parameter defines the minimum number of digits the user must dial for Prefix
code dialing.
00 00 ~ 30
Max Digits 3 This parameter defines the maximum number of digits the user must dial for Prefix
code dialing. When the maximum digits are dialed, the dialed digits are compared to
the assigned Prefix code.
00 00 ~ 30
Sending
Complete
4 When enabled (On), the system uses Enblock sending for Prefix dialing. When the
Enblock Inter-digit timer (PGM 182, Flexible button 10) expires or the 'Maximum
digits' is reached, the system sends all digits.
0 (Off) 0 = Off
1 = On
Number of Type 5 This parameter defines the Type of called number network. 0 = Unknown 0 = Unknown
1 = International
2 = National
To Next Page
Loading...
