Issue 2.2
Feature Description and Operation Manual
200
13.12 Outgoing Access Control
Description
An Attendant can take a CO line out-of-service for outgoing calls. When disabled, calls cannot
be placed on the CO line however, incoming CO calls are not affected.
Operation
To set a CO line in/out-of- service for outgoing calls from the Attendant,
1. Press the [TRANS/PGM] button.
2. Dial ‘0 7 3’.
3. Press the desired CO line button; confirmation tone is received and the status of then
selected CO line toggles between in and out-of-service>
4. Hang-up to return to idle.
Consideration
The LED of a disable CO line will flash rapidly at the Attendant station and will be steady
‘On’ at all other stations with an appearance of the CO line.
The Attendant can change the outgoing service status of a CO line while the line is busy
or idle.
Reference
A. Basic Outgoing Line Access
Administration
Attendant Assignment (PGM 164)
Assigns System and Main Attendants
To Next Page
Loading...
