ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
68
3.3.4 ISDN/IP CO Line Attributes (PGM 143)
PGM 143 assigns attributes associated with ISDN or VoIP to the CO line range.
Procedure:
1. Press the [TRANS/PGM] button.
2. Dial 143.
3. Enter the appropriate CO line Range.
4. Select the desired Flexible button. For Numbering Plan Id, Flexible button 8, select Flexible button 1 for Calling or Flexible button 2 for
Called numbers.
5. Enter the appropriate value.
6. Press the [Hold/Save] button.
PGM
143
Flex
Btn
Description Default Values
COLP Table
Index
1 This parameter defines the index to the COLP Table (PGM 201) used to determine
the COLP sent by the system. If the index is 50, the COLP is determined from PGM
114, Flexible button 5.
Not assigned 00 – 50
Delete softkey = Not
assigned
CLIP Table Index 2 This parameter defines the index to the COLP Table (PGM 201) used to determine
the CLIP sent by the system. If the index is 50, the CLIP is determined from PGM
114, Flexible button 5.
Not assigned 00 – 50
Delete softkey = Not
assigned
Call Type 3 This parameter defines the call type for the ISDN CO line CLI. 2 (National) 0 = Unknown
1 = International
2 = National
3 = Not used
4 = Subscriber
DID Conversion 4 This parameter defines the DID digit conversion process for DID digits received from 0 (Use Digit Mask 0 = Digit Mask
To Next Page
Loading...
