ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
69
PGM
143
Flex
Btn
Description Default Values
Type the ISDN or IP CO line. After removal of digits, Flexible button 5, the DID number
treatment can be a simple conversion (0), no conversion (1) or simple conversion
with table look-up (2).
PGM 146) (PGM146)
1 = Use digits as is
2 = Flex DID Table
(PGM231)
DID Remove
Number
5 This parameter defines the number of digits to remove from the DID number
received. After digit removal, the ipLDK-60 can process a 2 to 4 digit DID number.
Digits are removed starting with the first received digit.
00 (no digits
removed)
00 – 99
ISDN Enblock
Send
6 If this parameter is ‘On’, dialed digits are sent using Enblock Sending, all digits are
sent at once (user dials # or Enblock timer –PGM 182 Flexible button 10 expires).
Otherwise, digits are sent using Overlap Sending, digits are sent as dialed. IP lines
must be assigned Enblock Sending.
0 (Overlap) 0 = Overlap Sending
1 = Enblock Sending
CLI Transit 7 When calls are rerouted (Call Forward) the system will send either the original Call
Line ID (ORI) or the forwarding station’s CLI (CFW).
0 (CFW) 0 = CFW
1 = ORI
Numbering Plan
Id
8 This parameter defines the “Type of Numbering Plan” the system will use in the
Information Element of the call Setup message. Flexible button 1 covers outgoing
calls (CLI) and Flexible button 2 covers incoming calls (COL).
Flexible button 1
Calling
0 (Unknown)
Flexible button 2
0 (Unknown)
Called
0 = unknown
1 = ISDN / Telephony
3 = Data
4 = Telex
6 = National Std
7 = Private
ISDN Call
Deflection/
Rerouting
9 This parameter defines which ISDN Supplementary Service is supported, Call
Deflection (Unconditional Forward) or Call Reroute (Call Forward No response).
0 (No service) 0 = No Service
1 = Call Deflection
2 = Call Reroute
ISDN 1 Dgt Rm 10 When this parameter is ‘On’, only the 1
st
digit is removed from the received DID
digits before the number is converted. (Intended for use in Italy only)
0 (Off) 0 = Off
1 = On
ISDN Call Proc. 11 If this parameter is ‘On’, call processing information is provided in-band. (Intended 0 (Off) 0 = Off
To Next Page
Loading...
