ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
70
PGM
143
Flex
Btn
Description Default Values
In-band Message for Italy only) 1 = On
CLI Type 12 This parameter controls how the ipLDK will generate the Id for an ISDN or IP line
call. The CLI Type can be:
0 – Use COLP/CLIP Table index (Flexible buttons 1 & 2 above.)
1 – Use Long CLI 1 (PGM 114, Flexible button 21)
2 – Use Long CLI 2 (PGM 114, Flexible button 22)
0 (Normal) 0 = Normal
1 = Long CLI 1
2 = Long CLI 2
Reserved 13
Screening
Indicator
14 This parameter defines the value used as the Screening Indicator element of the CLI
field in the ISDN Setup message for an outgoing call.
0 (User provided
– No service)
0 = User provided –
No service.
1 = User provided –
Pass
2. = User provided –
Fail
3. = Network
provided
Double CLI
Service
15 This parameter determines if the system will display the original CLI or Transit CLI
for calls rerouted (forwarded) by the ISDN or IP line.
0 (Transit) 0 = Transit
1 = Original
Prefix Table
Index
16 This parameter enables Prefix dialing and defines the Enblock Prefix Table (PGM
205) index to use for the CO line. (Intended for Ukraine only)
0 (Off) 0 = OFF
1 ~ 6 = Table Index
Deny Incoming
Call
17 A CO line can be configured not recognize an incoming call. 0 (Off) 0 = Off
1 = On
ICLID 18 A CO Line can be configured to route a call based on the Incoming Caller ID (ICLID).
The ICLID is compared to the ICLID Table entries, PGM 237 to determine routing.
0 (Off) 0 = Off
1 = On
Drop if No CLI 19 A CO Line can be configured to drop a call if the CO line does not provide CLI. 0 (Off) 0 = Off
1 = On
To Next Page
Loading...
