ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
172
3.9.12 Mobil Extension (PGM 236)
PGM 236 configures the characteristics of a Mobile Extension associated with each station port.
Procedure:
1. Press the [TRANS PGM] button.
2. Dial 236.
3. Dial a table index ‘01’ ~ ‘48’ for a station port
4. Select the desired Flexible button.
5. Enter the appropriate value.
6. Press the [Hold/Save] button.
PGM
236
Flex
Btn
Description Default Values
Allow Mobile
Extension
1 When enable (On), the system allows the station to activate the Mobile Extension
feature.
0 (Off) 0 = Off
1 = On
CO Group 2 This parameter assigns the CO line group to use when the system calls the Mobile
Extension. An ISDN or IP CO line group must be used.
01 01 ~ 24
Telephone Number 3 This parameter assigns the number the system dials to call the Mobile Extension. Not assigned Up to 24 digits
CLI Number 4 This parameter assigns the CLI the system receives for an incoming call from the
Mobile Extension.
Not Assigned Up to 16 digits
Mobile Extension
Hunt Call
5 When enabled (On), Hunt group calls to the associated station alert to the Mobile
Extension.
0 (Off) 0 = Off
1 = On
Voice Message
Notification
6 When enable (On), the system sends an SMS to the Mobile when a voice mail is
received for the associated station. PSTN SMS must be available.
0 (Off) 0 = Off
1 = On
Mobile Extension
Usage
7 When enabled (On), the Mobile Extension feature is activated. This is the same as
the user dialing ‘34’ to Activate Mobile Extension.
0 (Off) 0 = Off
1 = On
To Next Page
Loading...
