ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
34
PGM
114
Flex
Btn
Description Procedure Values
normal DTMF tones or as part of the Keypad Facility message. 1 = Keypad
Long/Short 7 Not used.
CPN Type 8 not available
Reserved 9
DISA Restriction 10 If this parameter is ‘On’, the station cannot receive calls from a DISA line. 0 (Off) 0 = Off
1 = On
CLI Name
Display
11 When enabled (On), if the received CLI matches a Speed Dial number for the
station, the station LCD displays the Name of the Speed Dial.
0 (Off) 0 = Off
1 = On
ISDN CLI STA
12 When the CLI Type (Flexible button 17) is Short and the CLI is set as EXT (Flexible
button 5), this entry, up to 4 digits, is the CLI sent by the system.
Station number Up to 4 digits
Progress
Indication
13 When enabled (On), the Setup message from the ISDN and the ipLDK-60 Setup
Acknowledge message include a progress indication for calls from non-ISDN
devices.
0 (Off) 0 = Off
1 = On
CLI Restriction
(CLIR)
14 When enabled (On), the system sends the restrict CLI message when the station
places an outgoing call on an ISDN or IP line.
0 (Off) 0 = Off
1 = On
COL Restriction
(COLR)
15 When enabled (On), the system sends the restrict COL when the station answers an
ISDN or IP CO line.
0 (Off) 0 = Off
1 = On
DID Restriction 16 If this parameter is ‘On’, the station cannot receive DID calls. The DID call will be
treated as an invalid number.
0 (Off) 0 = Off
1 = On
DID Call Wait 17 If this parameter is set to ‘On’, a second DID call will camp-on to the busy Station. 1 (On) 0 = Off
1 = On
CLI Type
18 When the CLIP Table Index (PGM 143, Flexible button 2) is 50, and the CLI is EXT
(Flexible button 5), the CLI Type can be set as Short (Flexible button 12) or Long
(Flexible button 19)
0 (Short) 0 = Short
1 = Long
Long Station CLI 19 When the CLI Type (Flexible button 18) is Long and the CLI is set as EXT (Flexible No default Up to 12 digits (0 – 9)
To Next Page
Loading...
