ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
52
PGM
127
Flex
Btn
Description Default Values
VMON CO Grp 6 When Outbound Notification is enabled, the CO Line group to use to place the
outbound notification call can be configured.
01 01 ~ 24
VMON
Telephone
Number
7 When Outbound Notification is enabled, the telephone number to call must be
assigned.
24 digits
VMON Retry
Count
8 Should the notification fail (error, busy, or no-answer) the system will retry the
outbound call up to 9 times. After the assigned number of attempts, the system
abandons the notification.
2 1 ~ 9
VMON Retry
Interval
9 Should the notification fail, the system will attempt the call again after the “VMON
Retry Interval” time.
10 seconds 01 ~ 60 seconds
Cascade
Destination
10 The system can send a copy of a received voice mail to another Voice mailbox.
Flexible button 1 = Station
Flexible Button 2 = Voice Mailbox number
Button 1 – Station
Number
Button 2 – Voice
Mailbox Number
Cascade Type 11 The system will send a copy of a new message under one of several conditions as
assigned here.
0 (no cascade) 0 – No Cascade
1 – Immediate
2 - Notify Failure
3 – Urgent
Email Notification 12 The system can be configured to send an e-mail to the user as notification of a new
voice message.
0 (Off) 0 = Off
1 = On
Authorization
Code (Password)
13 Access to a Voice Mailbox can be password protected, when the user enters the
mailbox, the system will request entry of the password.
Station Number 11 digits
SMTP Server 14 When e-mail notification is on, the SMTP (Simple Mail Transfer Protocol) server IP
address must be configured.
IPv4 Address
Email Address 15 When e-mail notification is enabled, the e-mail address to notify must be configured. 24 Characters
To Next Page
Loading...
