ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
80
PGM
155
Flex
Btn
Description Default Values
DCO Subnet
Mask
5 This parameter defines the subnet mask of the digital CO board (E1/T1/PRI) used to
upgrade the board firmware when required.
0.0.0.0 IP v4 IP address
xxx.xxx.xxx.xxx
Reserved 6 not used
DCO Master
Clock
7 This parameter determines the master clock for the digital CO board. When set to
slave, the board will derive the clock signal from the connected circuit. When set to
master, the digital CO board will employ the local clock as the master clock signal
and expects the connected circuit to synchronize to the clock.
0 (Slave) 0 = Slave
1 = Master
PLL SSCG 8 not used
T1 Setup mode 9 This parameter assigns the type of framing for the T1 circuit as D4 or ESF. 0 (D4) 0 = D4
1 = ESF
T1 Line Mode 10 This parameter assigns the Line coding for the T1 circuit as B8ZS or AMI. 0 (B8ZS) 0 = B8ZS
1 = AMI
To Next Page
Loading...
