ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
82
PGM
160
Flex
Btn
Description Default Values
CO Dial-Tone
Detect
6 When enabled, the system uses dial tone detection when a pause is detected in a
Speed Dial number otherwise the Pause timer (PGM 181, Flexible button 11) is
used.
0 (Off) 0 = Off
1 = On
External Night
Ring
7 If this parameter is ‘On’, when an incoming CO call is received and UNA service is
activated, alerting will be sent to the LBC contact.
0 (Off) 0 = Off
1 = On
Hold Preference 8 This parameter defines the preferred type of Hold, System (anyone with an
appearance may access the held call) or Exclusive (only the holding station can
access the held call).
1 (System) 0 = Exclusive
1 = System
Multi-line
Conference
9 When enabled (On), the system will allow multiple parties, up to 14, in a conference. 1 (On) 0 = Off
1 = On
Print LCR
Converted Digit
10 This parameter determines if the DKT LCD and SMDR will show the digits dialed by
LCR (On) or the originally dialed digits (Off).
0 (Off) 0 = Off
1 = On
Conference
Warning Tone
11 If this parameter is ‘On’, when a member joins a Conference Room, existing
members hear a warning tone.
1 (On) 0 = Off
1 = On
Off-net Prompt
Usage
12 If this parameter is ‘On’, the Off-net VMIB prompt is heard when a call is forwarded
over a CO line.
1 (On) 0 = Off
1 = On
Off-net DTMF
Tone
13 This parameter determines if DTMF tones are returned to a caller on a CO line when
forwarded Off net.
1 (On) 0 = Off
1 = On
Voice Path
Connect
14 This parameter determines if a voice path to an outgoing CO line is set-up
immediately (IMM) or after dialing the first digit (DGT) when a CO line is assigned for
PBX operation in PGM 141, Flexible button 5.
0 (After dialing) 0 = After digits
1 = Immediate
Transfer Tone 15 This parameter determines if a call receives Ring Back tone or MOH during a
transfer.
0 (Ring Back) 0 = Ring Back Tone
1 = MOH
CO to CO Xfer
CPT detection
16 See PGM 142, Flexible button 18.
To Next Page
Loading...
