ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
127
PGM
186
Flex
Btn
Description Default Values
seconds) second increments
R2 Ready Timer
7 This parameter determines the time between receipt of a line seize and seize
acknowledge signal for an incoming call.
007 (140 milli-
seconds)
000 ~ 500 in 20-milli-
second increments
Dial Tone Delay
Timer
8 not used
Line Status 9 This parameter defines the code the system will send to indicate idle line status in
accordance with E1R2 specifications.
6 1 ~ 9
Calling Category 10 This parameter defines the code sent in response to a call category request from the
network in accordance with E1R2 specifications.
1 1 ~ 9
ANI Request 11 When enabled (On), in accordance with E1R2 specifications, the system will request
ANI (Automatic Number Identification) from the network as the CLI for the call.
0 (Off) 0 = Off
1 = On
CLI Digit Num 12 not used
R2 OUT DIGIT
TIMER
13 This parameter sets the Inter-digit time for R@ signaling on a digital CO line. 05 seconds 01 ~ 50 in 1-second
increments
R2 ERROR
PROMT USAGE
14 When enabled (On), the system will play the VMIB error announcement when an
error occurs on an R2 outgoing call. If no VMIB announcement is available, the
system sends error tone.
0 (Off) 0 = Off
1 = On
R2 BUSY
PROMT USAGE
15 When enabled (On), the system will play the VMIB busy announcement when a busy
condition occurs on an R2 outgoing call. If no VMIB announcement is available, the
system sends busy tone.
0 (Off) 0 = Off
1 = On
R2 ANNOUNCE
PROMT USAGE
16 When enabled (On) and the R2 line returns an ANNOUNCE message indicating the
destination number is invalid, etc., the VMIB error announcement is played. If no
VMIB announcement is available, the system sends error tone.
0 (Off) 0 = Off
1 = On
DCO Gain 17 This parameter defines the gain used to supply R2MFC tones to the digital CO line
over the voice path.
32 01 ~ 63
To Next Page
Loading...
