ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
185
PGM
324
Flex
Btn
Description Default Values
Alternate Dial Bin 5 This parameter defines the alternate route when a network fault occurs while
attempting to route a networked call. A System Speed Dial is used to define the
alternate route.
Not assigned 2000 ~ 2499
Destination MPB
IP
6 This parameter defines the IP address of the receiving MPB for DECT and for the
BLF Manager support.
0.0.0.0 IP v4 address
Digit Repeat 7 When enabled (Yes), the system will repeat digits received from the networked
system for output over the outgoing PSTN connection.
0 (No) 0 = No
1 = Yes
CO ATD Code
CLI
8 When enabled (On), the Attendant station number associated with the CO line is
used as the CLI sent to PX. Otherwise, the station number placing or receiving the
call is used for the CLI.
0 (Off) 0 = Off
1 = On
Firewall Routing 9 When enabled (On), the system recognizes the connection for the Network
Numbering Plan code routes through a Firewall and uses the WAN side Firewall
address to complete the connection.
0 (No) 0 = No
1 = Yes
Authorization
Code COS Use
10 When enabled (Yes), the user must enter an Authorization code. The COS
associated with the Authorization code establishes toll restriction for the call.
0 (No) 0 = No
1 = Yes
SMDR Hidden
Digits
11 When enabled, digits dialed by the station user are NOT output in SMDR records. 0 (No) 0 = No
1 = Yes
To Next Page
Loading...
