ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
188
PGM
340
Flex
Btn
Description Default Values
purpose of reducing jitter. A short jitter buffer may result in loss of RTP packets, a
long jitter buffer may result in excessive delay.
second increments
Voice Monitor 17 When enabled, the system will monitor the RTP traffic to/from the VOIB. 0 (Off) 0 = Off
1 = On
H.323 (Fast)
Mode
18 When enabled (On), the system will implement the H.323 Fast call set-up mode. 0 (Fast) 0 = Fast
1 = Normal
Early H.245 19 When enabled (On), the system will employ the Early H.245 channel set-up
operation for H.323.
0 (Off) 0 = Off
1 = On
H.245 Tunneling 20 When enabled (On), the system will implement tunneling of H.245 messages in QSig
messages.
0 (Off) 0 = Off
1 = On
TOS Precedence 21 This parameter defines the setting for bits 0 – 2 of the IP TOS byte. Precedence can
be set from 0, the lowest precedence, to 7 the highest precedence.
0 0 ~ 7
FAX Mode 22 When enabled (On), the system implements T.38 IP FAX detection using the
receiver Re-Invite message. Otherwise, the initial Invite contains the T.38
parameters.
0 (Off) 0 = Off
1 = On
Dial Pad Character Chart
1 – 10
‘.’ – 13
Q – 11
Z – 12
2 – 20
A – 21
B – 22
C – 23
3 – 30
D – 31
E – 32
F – 33
4 – 40
G – 41
H – 42
5 – 50
J – 51
K – 52
6 – 60
M – 61
N – 62
To Next Page
Loading...
