Issue 2.2
Feature Description and Operation Manual
83
4. If the called station is busy, a Call Back is activated. If the called station does not
answer or is in DND, a Station Message Wait is activated.
To respond to a Station Message Wait from an SLT,
1. Lift the handset; stutter dial tone indicates a message waiting.
2. Dial 5 5 7, the Call Back/Station Message Wait response code.
3. An intercom call is place to the station that left the message.
Consideration
A station may receive a Call Back from any or all stations however, after the first Call
Back, additional Call Back requests are stored as Message Waits.
A station may have a maximum of five (5) Station Message Waits.
Station Message Waits are protected from a power failure.
The user activating Call Back must respond to the Call Back recall in 30 seconds or the
Call Back request is terminated and a Message Wait is activated to the station from the
originally called station.
The ipLDK-60 does not support SLT MWI lamps.
When calling a station assigned a VMIB Voice mailbox (refer to Ref. C), activating
message wait will connect the user to the station’s mailbox and the greeting is played.
The user may hang-up to leave a Station Message Wait or after the greeting may leave a
voice message. If a voice message is left, the Station Message Wait is cancelled and
the Voice Message is registered. In either case, the station receives the message.
Placing a call to a station after leaving a Station Message Wait/Call Back will cancel the
Station Message Wait/Call Back.
Message Wait reminder tone repeats at a programmable interval, 01 to 60 minutes.
Message Wait reminder remains active until all the messages are retrieved.
For Call Backs and returning a Station Message Wait, the ipLDK employs tone ringing
intercom calls, overriding the assigned Intercom Signaling Mode (refer to Ref. A).
Reference
A. Intercom Signaling Mode
B. DND
C. VMIB Voice Mail
Admin Programming
System Numbering Plan (PGM 106, Flexible button 13)
Assigns the code for SLTs to activate Station Message Wait/Call Back
System Numbering Plan (PGM 106, Flexible button 14)
Assigns code for SLTs to respond to a Message Wait
Station ID Assignment (PGM 110, Flexible button 1)
Assigns the type of station terminal
MW Reminder Timer (PGM 181, Flexible button 9)
Assigns and sets reminder tone for message waiting
To Next Page
Loading...
