ENGINE SPEED SENSING POWER STEERING
N15
N
Upper Bearing, Oil Seal Disassembly Note
1. Set the SST as shown.
2. Using a press, remove the oil seal and upper
bearing without applying pressure to the edge of
the valve housing.
Holder Disassembly Note
1. Cut away the staked area by using a drill.
Caution
•
••
• Carefully pull out the holder without
damaging the U gasket.
2. Disassemble the holder.
Oil Seal, Inner Guide Disassembly Note
1. Set the SSTs into the valve side.
2. Install the SST to the gear housing.
3. Press out the oil seal and inner guide.
Mounting Rubber Disassembly Note
• Press the mounting rubber out from the gear
housing using the SSTs and a press.
End Of Sie
A6E0612W035
A6E0612W037
A6E0612W086
A6E0612W040
To Next Page
Loading...
