Mazda 6 2002 - Page 914

T62
WIPER AND WASHER
REAR WIPER MOTOR REMOVAL/INSTALLATION
A6E811667450W01
1. Disconnect the negative battery cable.
2. Remove the rear wiper arm and blade. (See T63 REAR WIPER ARM AND BLADE REMOVAL/
INSTALLATION.)
3. Remove the liftgate lower trim. (See S95 LIFTGATE LOWER TRIM REMOVAL/INSTALLATION)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Adjust the rear wiper arm and blade. (See T64
REAR WIPER ARM AND BLADE
ADJUSTMENT.)
End Of Sie
REAR WIPER MOTOR INSPECTION
A6E811667450W02
1. Disconnect the negative battery cable.
2. Remove the liftgate lower trim. (See S95 LIFTGATE LOWER TRIM REMOVAL/INSTALLATION)
3. Disconnect the rear wiper motor connector.
4. Connect battery positive voltage to the rear wiper motor terminal A and the ground to a bare metal part of the
vehicle and the rear wiper motor terminal B.
5. Verify that the rear wiper motor operates.
6. Disconnect the ground to the terminal B while the
rear wiper is operating.
1 Connector
2 Outer bushing
3Bolt
4 Rear wiper motor
A6E8116W110
A6E8116W119
A6E8116W132