Mazda 6 2002 - Page 979

AIR BAG SYSTEM
T127
T
End Of Sie
PASSENGER-SIDE AIR BAG CUT-OFF INDICATOR LIGHT REMOVAL/INSTALLATION
A6E813001046W02
1. Remove the center panel module. (See T96 CENTER PANEL MODULE REMOVAL/INSTALLATION.)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
End Of Sie
AIR BAG MODULE AND PRE-TENSIONER SEAT BELT DEPLOYMENT PROCEDURES
A6E813057000W01
Warning
•
••
• A live (undeployed) air bag module and pre-tensioner seat belt may accidentally deploy when it is
disposed of and cause serious injury. Do not dispose of a live (undeployed) air bag module and
pre-tensioner seat belt. If the SSTs (Deployment tool and Adapter harness) are not available,
consult the nearest Mazda representative for assistance.
Caution
•
••
• Deploying the air bag modules and pre-tensioner seat belts inside the vehicle may cause damage
to the vehicle interior. When the vehicle is not to be scrapped, always deploy the air bag modules
and pre-tensioner seat belts outside the vehicle.
• When the vehicle is to be scrapped, deploy the air bag modules and pre-tensioner seat belts inside the vehicle.
(See T127 Deployment Procedure for Inside of Vehicle (Only When Vehicle Is To Be Scrapped).)
• When the vehicle is not to be scrapped, deploy the air bag modules and pre-tensioner seat belts outside the
vehicle. (See T131 Deployment Procedure for Outside of Vehicle.)
Note
• When disposing of deployed air bag module and pre-tensioner seat belt, refer to the disposal procedure,
(See T139 AIR BAG MODULE AND PRE-TENSIONER SEAT BELT DISPOSAL PROCEDURES.)
Deployment Procedure for Inside of Vehicle (Only When Vehicle Is To Be Scrapped)
1. Inspect the SST (Deployment tool). (See T140 INSPECTION OF SST (DEPLOYMENT TOOL).)
2. Move the vehicle to an open space, away from strong winds, and close all of the vehicles doors and windows.
3. Turn the ignition switch to LOCK position.
4. Disconnect the negative battery cable and wait for more than 1 minute.
5. Follow the appropriate procedure for deploying the driver-side air bag module, passenger-side air bag module,
side air bag module, curtain air bag module, or pre-tensioner seat belt.
Driver-side air bag module
Warning
•
••
• Driver-side air bag module is the dual inflator type. When the inflators are forced to be deployed
simultaneously, one of them may fail to deploy. When disposing the air bag module, the inflators
may be deployed accidentally. Make sure to deploy the inflators sequentially, following the
procedures below.
1. Remove the driver-side air bag module. (See T120 DRIVER-SIDE AIR BAG MODULE REMOVAL/
INSTALLATION.)
1Socket
2 Passenger-side air bag cut-off indicator light bulb
A6E8130W057