Mercury BRAVO

POWER STEERING
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 6A-13
7. Connect the power steering unit to the steering lever.
a. Lubricate the clevis pins with Special Lubricant 101.
b. Install the clevis pin in the clevis from the top.
c. Secure the pin in the clevis with a cotter pin. Spread the cotter pin ends.
8. Lubricate the steering cable end with a liberal amount of Special Lubricant 101 and
install the cable through the guide.
9. Start the coupler nut on the cable guide tube. Do not tighten at this time.
10. Connect the cable end to the clevis with the forward clevis pin. Spread the cotter pin
ends.
71901
e
g
a
b
h
c
d
f
Control Valve
a-Clevis
b-Rear Clevis Pin
c-Forward Clevis Pin
d-Steering Cable End
e-Cable Guide
f-Pivot Bolt
g-Coupler Nut
h-Cotter Pins