POWER STEERING SERVICE MANUAL NUMBER 28
Page 6A-14 90-863160 MAY 2000
11. Using a suitable wrench hold the flat surfaces on the cable guide tube in the vertical posi-
tion. Torque coupler nut to 35 lb-ft (47 Nm). Be certain the flat surfaces are still
aligned vertically after torque is applied to coupler nut.
73901
a
b
a-Flat
b-Suitable Wrench
12. Install power steering hoses to power steering assembly.
a. Torque both fittings to 23 lb-ft (31 Nm). Route hoses as described in section 2A to
avoid contact with the steering system components.
To Next Page
Loading...
