ACCESSORIES - ALL MODELS SERVICE MANUAL NUMBER 28
Page 8A-12 90-863160 MAY 2000
24. Install a new O-ring onto the shaft end plug.
25. Lightly lubricate the O-ring with 2-4-C Marine Lubricant with Teflon and insert the plug
into the shaft end. Be careful not to damage the O-ring. A damaged O-ring will cause
a vacuum leak.
26. Align the cotter pin holes and secure the end plug to the shaft with a cotter pin. Spread
both ends of the cotter pin.
50422
50424
50423
a
b
c
c
d
a-O-ring
b-Shaft End Cap
c-Cotter Hole(s)
d-Cotter Pin Ends
27. Liberally apply 2-4-C Marine Lubricant with Teflon to each side of the slide rails and
wheel.
50426
a
b
a-Slide Rails
b-Wheel
28. Install a paper gasket onto the end plate. Hold the gasket in place with 2-4-C Marine
Lubricant with Teflon.
To Next Page
Loading...
