NEC ELECTRA ELITE IPK II - Page 137

___________________________________________________________________________________
Electra Elite IPK II Document Revision 3
System Hardware Manual xiii
___________________________________________________________________________________
Figure 6-53 EliteMail CTI Port Expansion Board .......................................................................6-101
Figure 6-54 CTP( )-U10 ETU (Front View) ...............................................................................6-104
Figure 6-55 CTP( )-U10 ETU (Back View) ................................................................................6-105
Figure 6-56 Before Installing the Drive ......................................................................................6-106
Figure 6-57 Line up Four Screws ..............................................................................................6-107
Figure 6-58 Slide Drive Toward Connector ...............................................................................6-107
Figure 6-59 Loosen the Four Screws ........................................................................................6-108
Figure 6-60 Push Drive Toward Backplane ...............................................................................6-108
Figure 6-61 Lift up and Remove Drive from ETU ......................................................................6-109
Figure 6-62 Insert Brass Connector End ...................................................................................6-109
Figure 6-63 Push Other End Down Until it Locks ......................................................................6-110
Figure 6-64 FMS(2)/(4)-U( ) ETU ...............................................................................................6-113
Figure 6-65 FMS(8)-U( ) ETU ....................................................................................................6-114
Figure 6-66 FMS-U30 ETU ........................................................................................................6-115
Figure 6-67 VMP( )-U40 ETU ...................................................................................................6-122
Figure 6-68 Installing the Flash Drive on the VMP( )-U40 ETU ................................................6-123
Figure 6-69 Flash Drive Seated on VMP( )-U40 ETU ................................................................6-124
Figure 6-70 Connecting the Hard Drive .....................................................................................6-125
Figure 6-71 Plus Sign on Battery Displayed Up ........................................................................6-126
Figure 6-72 Connecting the Ribbon Cable ................................................................................6-127
Figure 6-73 Leaving Four Pins Unconnected ............................................................................6-128
Figure 6-74 Placing the Hard Drive on the ETU ........................................................................6-128
Figure 6-75 Placing the Four Mounting Screws .........................................................................6-129
Figure 6-76 Installing the DSP-U30 on the VMP( )-U40 ETU ....................................................6-131
Figure 6-77 VMS(2)/(4)/(8)-U( ) ETU ........................................................................................6-136
Figure 6-78 VMS-U30 ETU ........................................................................................................6-137
Figure 6-79 BSU(4M)-U20 ETU .................................................................................................6-143
Figure 6-80 BSU(2S)-U20 ETU .................................................................................................6-146