Oce plotwave 345 User Manual

Restore the factory defaults of the templates
Introduction
You can restore the factory defaults of all templates with Océ Express WebTools.
The custom templates are not changed.
Procedure
1.
Select the [Preferences] - [Scan] tab in Océ Express WebTools for the scan templates.
2.
Click on [Restore factory defaults] at the right hand side.
3.
The system displays the message [Restore all factory default templates?]
4.
Click [Ok] to restore the templates or [Cancel] to stop the restore.
Restore the factory defaults of the templates
100
Chapter 3 - Define your Workflow with Océ Express WebTools

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)