Oce plotwave 345 User Manual

Move the Printing System
Turn off the printing system
Introduction
When you want to turn off the printing system completely, you have to take a few steps.
Procedure
1.
Use the [on / off button] at the front of the printer to turn the printing system off. The lighted
button starts to blink.
NOTE
You can also use the [Shut down] button in Océ Express WebTools.
IMPORTANT
Wait until the [on / off button] stops blinking.
Move the Printing System
Chapter 5 - Maintain the Printing System
213

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)