Oce plotwave 345 User Manual

File type
Depending on the color mode and file type you select, the values for the compression mode and
organization change. For some file types and some situations, the compression and organization
settings cannot be set. The list below helps you to define the correct file type and color mode,
and shows you which compression and organization settings are possible.
NOTE
On the user panel you can set an automatic compression value. The controller determines the
most common compression method for the file type that is selected.
The automatic compression value can be found on the user panel under the scan tile. Tap the
scan tile twice and select [File type]. Set the compression to automatic under:
• [PDF compression] (when PDF is selected)
• [PDF/A compression] (when PDF/A is selected)
• [TIFF compression] (when TIFF is selected)
Color mode: Color
[Color] mode [File type] [Organization] [Compression] [JPEG quality]
[Color] [TIFF]
[TIFF multipage]
[Raw]
[Striped]
[Tiled]
[LZW]
[Packbits]
[None]
Not applicable
[PDF]
[PDF multipage]
Not applicable [File type]
[LZW]
[None]
Not applicable
[JPEG] [Maximum]
[High]
[Medium]
[Low]
[PDF/A]
[PDF/A multi-
page]
Not applicable [Flate]
[None]
Not applicable
[JPEG] [Maximum]
[High]
[Medium]
[Low]
[JPEG] Not applicable Not applicable [Maximum]
[High]
[Medium]
[Low]
File type
Chapter 4 - Use the Printing System
201

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)