Oce plotwave 345 User Manual

Configure the working hours
Introduction
You can define the working hours of the printer in Océ Express WebTools.
Enable [Automatic on] first, to let the printer wake up automatically. Define the working days with
the [First workday] setting, for example 'Monday', and [Last workday] setting, for example
'Friday'. And set the wake up time and shut down time with the [Start-up time] and [End of
workday time] settings, for example '06:30' and '19:00'.
That way the printer turns on and off automatically, at the set day and time.
NOTE
It is not possible to disable the automatic shut down of the printer with this setting. The printer
will always shut down once in twenty-four hours, due to power saving regulations.
Procedure
1.
Open the [Preferences] - [System defaults] tab.
2.
Click on [Edit] in the [Printer properties] section.
3.
Set the [Automatic on] setting to [Enabled].
4.
Set the [Start-up time], [End of workday time], [First workday] and [Last workday] settings
according to your preferences.
5.
Click [Ok] to confirm, or [Cancel] to reject your entries.
Result
The printer now wakes up automatically, and is active during the preferred time frame on the set
days.
Configure the working hours
118
Chapter 3 - Define your Workflow with Océ Express WebTools

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)