Oce plotwave 345 User Manual

Configure Océ Express WebTools settings for a mobile connection
Introduction
If you want to give users easy access to Océ Mobile WebTools, the settings must first be
configured. With the information you can develop a QR card to create easy access.
NOTE
• For this procedure, you need to log in as Key Operator or Power User.
• Make sure you configure your Wi-Fi network and connect the printer to the network.
Procedure
1.
Open the [Configuration] - [Connectivity] tab.
2.
Click [Edit] in the right hand corner of the [Mobile] section.
3.
Enter the settings. This information will also be printed on the QR card:
NOTE
Enter information according to your IT policy. Contact your system administrator for
more information.
Mobile section in Océ Express WebTools
Setting Action
[Wi-Fi name on QRC sheet] Enter the name of your Wi-Fi network.
The name will be displayed on the QR card.
[Wi-Fi key on QRC sheet] If required, enter the password for your Wi-Fi network.
The key will be displayed on the QR card.
4.
Click [Ok] to confirm your settings.
NOTE
When the printer is in a Windows domain network, enter the domain name in Océ
Express WebTools:
- Open the [Configuration] - [Connectivity] tab
- Go to the [Network adapter] section. Enter the domain name in the field [Primary DNS
suffix].
Configure Océ Express WebTools settings for a mobile connection
Chapter 3 - Define your Workflow with Océ Express WebTools
133

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)