Oce plotwave 345 User Manual

Configure the locations
Configure your locations
Introduction
On the user panel you can find a list of locations you can scan to and print from.
To this location you send your scanned files for storage, or you save files on this location and you
send them to the printer.
You can define the external locations under the [Configuration] - [External locations] tab in Océ
Express WebTools.
Type of locations
You can scan to and print from various location types.
Location type Location type description
Smart Inbox If you select this location, you can print from your personal Smart In-
box, or your scanned file is sent to the Smart Inbox of your choice.
[USB] If you select this location you can print from or scan to the USB Mass
storage device you inserted in the user panel.
[FTP] If you select this location you can print from or scan to a shared folder
on a remote workstation via FTP.
[SMB] If you select this location you can print from or scan to a shared folder
on a remote workstation via SMB.
[WebDAV] If you select this location type, you can enter the cloud via WebDAV
and use it as a network drive.
[Home folder] When you select this location type, you can print from or scan to your
personal home folder on your own workstation.
NOTE
The home folder is only available when [User authentication]
is enabled with [User name and password].
[PlanWell® Collabo-
rate](Optional)
When you select this location you can print from or scan to the Plan-
Well Collaborate cloud services.
Configure the locations
102
Chapter 3 - Define your Workflow with Océ Express WebTools

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)