Oce plotwave 345 User Manual

Configure the pen settings
Introduction
You can define the pen settings in the application that you use to create a drawing with. When
the pen settings are not defined in the application, you can configure the default pen settings in
Océ Express WebTools.
Procedure
1.
Open the [Preferences] - [Print job defaults] tab.
2.
Go down to the list of pen numbers.
3.
Click on the value of the pen number that you want to change.
The pen settings window opens. You can configure the color, width and pattern for this pen.
4.
Click on [Ok] to confirm or [Cancel] to reject your entries.
Configure the pen settings
Chapter 3 - Define your Workflow with Océ Express WebTools
123

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)