Oce plotwave 345 User Manual

Install the system security patches in Océ Express WebTools
Introduction
You can install system security patches in Océ Express WebTools.
Before you begin
Download the system security patches from "http://downloads.oce.com" .
NOTE
• When the system update package is larger than 2 GB and you use Internet Explorer, you must
use Internet Explorer version 9 or higher.
• Do not restart the printer during the upload and update process.
Procedure
1.
Select the [Support] - [Update] tab.
2.
Click on the [Install] button for an installation of the system patches.
3.
Browse to the location of the [Software package (*.oce)] patch file.
Select the file and click 'Open'.
4.
Click [Ok] to confirm, or [Cancel] to reject your entries.
5.
You are now ready to install the patches. A warning message appears.
Click [Ok] to confirm, or [Cancel] to reject your entries.
6.
The installation starts. At the end of the process, the controller restarts.
Click [Ok] to open Océ Express WebTools.
7.
You are informed whether the installation was successful.
Install the system security patches in Océ Express WebTools
212
Chapter 5 - Maintain the Printing System

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)