Oce plotwave 345 User Manual

Access control and IPsec settings
Introduction
When access control is enabled, you can edit the access control settings.
[Access control] and IPsec settings
Under [Security] - [Configuration] - [Access control], you can set the following settings for each of
the 5 stations:
Setting Description
[Access control sta-
tion 1]
Enable or disable communication of this host with the printer.
[Access control sta-
tion 1: IPv4 address]
The IPv4 address of the host is allowed to connect to the printer.
[Access control sta-
tion 1: IPv6 address]
The IPv6 address of the host is allowed to connect to the printer.
[IPsec station 1] Enable or disable IPsec. IPsec is a security protocol that encrypts the
communication between the host and the printer.
[IPsec station 1: Pre-
shared key]
The key for encryption of this host connected via IPsec. If empty, the de-
fault preshared key is used.
For IPsec., you can set the following setting:
Setting Description
[IPsec default pre-
shared key]
This is the default key for encryption of hosts connected via IPsec. This
key holds for all stations whose preshared key is unspecified.
NOTE
For more details on these settings please consult the Océ PlotWave-ColorWave Systems
Security manual.
Access control and IPsec settings
Chapter 3 - Define your Workflow with Océ Express WebTools
77

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)