Oce plotwave 345 - Set the Long Plot Mode

Set the long plot mode
Introduction
When the [Long plot mode] setting is enabled, it allows you to print plots up to eight times longer
than when the setting is disabled.
For the printer to be able to print long prints, the print quality can be reduced.
NOTE
The setting does not apply for PDF or PostScript files.
Procedure
1.
Open the [Preferences] - [Print job defaults] tab.
2.
Click on [Edit] in the [General (non-postscript) rasterization settings] section or click on the [Long
plot mode] setting.
3.
Enable or disable. The setting is enabled when you check the box.
4.
Click on [Ok] to confirm or [Cancel] to reject your entries.
Set the long plot mode
126
Chapter 3 - Define your Workflow with Océ Express WebTools